Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 296/970
Command Mode
Global Config
6.9.2.4 cdp holdtime
This command is used to configure the hold time (seconds) of CDP.
Syntax
cdp holdtime <10-255>
<10-255> - interval time (Range: 10 – 255).
no - This command is used to hold time to the default value.
Default Setting
180
Command Mode
Global Config
6.10 SNTP (Simple Network Time Protocol) Commands
6.10.1 Show Commands
6.10.1.1 show sntp
This command displays the current time and configuration settings for the SNTP client, and
indicates whether the local time has been properly updated.
Syntax
To Next Page
Loading...
Need help?
General
