Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 429/970
Privileged Exec
Display Message
Connected Routes: The total number of connected routes in the routing table.
Static Routes: Total number of static routes in the routing table.
RIP Routes: Total number of routes installed by RIP protocol.
OSPF Routes: Total number of routes installed by OSPF protocol.
Total Routes: Total number of routes in the routing table.
7.2.1.12 show ip route precedence
This command displays detailed information about the route preferences. Route preferences
are used in determining the best route. Lower router preference values are preferred over
higher router preference values.
Syntax
show ip route preferences
Default Setting
None
Command Mode
Privileged Exec, User Exec
Display Message
Local: This field displays the local route preference value.
Static: This field displays the static route preference value.
OSPF Intra: This field displays the OSPF intra route preference value.
OSPF Inter: This field displays the OSPF inter route preference value.
OSPF Ext T1: This field displays the OSPF Type-1 route preference value.
OSPF Ext T2: This field displays the OSPF Type-2 route preference value.
RIP: This field displays the RIP route preference value.
7.2.1.13 show ip traffic
This command displays IP statistical information. Refer to RFC 1213 for more information
about the fields that are displayed.
Syntax
To Next Page
Loading...
Need help?
General
