Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 351/970
including loopback and tunnel interfaces. IPv6 statistics display in the output of the show ipv6
traffic command. If you do not specify an interface, the counters for all IPv6 traffic statistics
reset to zero.
Syntax
clear ipv6 statistics [{<slot/port> | loopback <loopback-id> | tunnel <tunnel-id>}]
<slot/port> - Specify the interface.
<loopback-id > - Specify loopback Interface ID. Range 0 -7.
<tunnel-id > - Specify the Tunnel ID. Range 0 -7.
Default Setting
None
Command Mode
Privileged Exec
6.17.1.25 clear ipv6 dhcp
This command will use to clear DHCPv6 statistics for all interfaces or for a specific interface.
Use the <slot/port> parameter to specify the interface.
Syntax
clear ipv6 dhcp {statistics | interface <slot/port> statistics}
<slot/port> - Specify the interface.
Default Setting
None
Command Mode
Privileged Exec
To Next Page
Loading...
Need help?
General
