Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 528/970
Default Setting
1
Command Mode
Interface Config
8.3.2.6 mrinfo
This command is used to query the neighbor information of a multicast-capable router specified
by [<ipaddr>]. The default value is the IP address of the system at which the command is
issued. The mrinfo command can take up to 2 minutes to complete. Only one mrinfo command
may be in process at a time. The results of this command will be available in the results
bufferpool which can be displayed by using "show mrinfo".
Syntax
mrinfo [<ipaddr>]
<ipaddr> - the IP address of the multicast capable router.
Default Setting
None
Command Mode
Privileged Exec
8.3.2.7 mstat
This command is used to find the packet rate and loss information path from a source to a
receiver (unicast router id of the host running mstat). The results of this command will be
available in the results bufferpool which can be displayed by using "show mstat". If a debug
command is already in progress, a message is displayed and the new request fails.
The <source> is the IP Address of the remote multicast-capable source. The [<receiver>] is the
IP address of the receiver. The default value is the IP address of system at which the command
is issued. The [<group>] is a multicast address of the group to be displayed. Default value is
224.2.0.1
To Next Page
Loading...
Need help?
General
