QUANTA LB4M - Area Range

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 453/970
Syntax
area <areaid> nssa translator-stab-intv <0-3600>
no area <areaid> nssa translator-stab-intv
<areaid> - Area ID.
<0-3600> - The range is 0 to 3600.
no - Disables the nssa translator’s <stabilityinterval> from the specified area id.
Default Setting
None
Command Mode
Router OSPF Config
7.3.2.12 area range
This command creates a specified area range for a specified NSSA.
Syntax
area <areaid> range <ipaddr> <subnetmask> {summarylink | nssaexternallink}
[advertise | not-advertise]
no area <areaid> range <ipaddr> <subnetmask>
<areaid> - Area ID.
<ipaddr> - IP Address.
<subnetmask> - The subnetmask.
summarylink - The lsdb type. The value is summarylink or nssaexternallink
nssaexternallink - The lsdb type. The value is summarylink or nssaexternallink
advertise - Allow advertising the specified area range.
not-advertise - Disallow advertising the specified area range.
<no> - This command deletes a specified area range.
Default Setting
None
Command Mode
Router OSPF Config