Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 604/970
<no> - This command sets the administrative mode of RIPng in the router to inactive.
Default Setting
Enabled
Command Mode
IPv6 Router RIP Config
9.5.2.2 ipv6 rip
This command enables RIPng on a router interface.
Syntax
Ipv6 rip
no ipv6 rip
<no> - This command disables RIPng on a router interface.
Default Setting
Disabled
Command Mode
Interface Config
9.5.2.3 default-information originate
This command is used to set the advertisement of default routes.
Syntax
default-information originate
no default-information originate
<no> - This command is used to cancel the advertisement of default routes.
Default Setting
Disabled
Command Mode
IPv6 Router RIP Config
To Next Page
Loading...
Need help?
General
