Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 711/970
11.2.2.6 Managing IP Subnet-based VLAN
11.2.2.6.1. IP Subnet-based VLAN Configuration Page
IP Subnet to VLAN mapping is defined by configuring an entry in the IP Subnet to VLAN table.
An entry is specified via a source IP address, network mask, and the desired VLAN ID. The IP
Subnet to VLAN configurations are shared across all ports of the device.
Selection Criteria
IP Address - Selects the IP Address bound to a VLAN ID. To add another IP
Subnet-based VLAN, select "Add" option.
Configurable Data
IP Address - Valid IP Address bound to VLAN ID. This field is configurable only when a
new IP Subnet Based VLAN is being created. IP Address in dotted decimal notation.
Subnet Mask - Valid Subnet Mask of the IP Address. This field is configurable only when a
new IP Subnet-based VLAN is being created. Subnet mask should be in dotted decimal
notation.
VLAN ID - VLAN ID can be any number in the range of (1 to 3965).
Command Buttons
Submit - Update the switch with the values on this screen. If you want the switch to retain
the new values across a power cycle, you must perform a save.
Delete - Delete an entry of IP Subnet to VLAN mapping.
To Next Page
Loading...
Need help?
General
