Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 465/970
Syntax
ip ospf priority <0-255>
no ip ospf priority
< 0-255 > - The range of the priority value is 0 to 255. A value of '0' indicates that the
router is not eligible to become the designated router on this network.
<no> - This command sets the default OSPF priority for the specified interface.
Default Setting
The default priority value is 1. It is the highest router priority.
Command Mode
Interface Config
7.3.2.32 ip ospf retransmit-interval
This command sets the OSPF retransmit Interval for the specified interface. The retransmit
interval is specified in seconds.
Syntax
ip ospf retransmit-interval <0-3600>
no ip ospf retransmit-interval
< 0-3600 > - The value is the number of seconds between link-state advertisement
retransmissions for adjacencies belonging to this router interface. This value is also used
when retransmitting database and link-state request packets.
<no> - This command sets the default OSPF retransmit Interval for the specified
interface.
Default Setting
To Next Page
Loading...
Need help?
General
