Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 599/970
dist
ance osp
f {intra
| inter | ty
pe1 | type2} <preference>
no distance ospf {intra | inter | type1 | type2}
<preference> - The range for intra is 1 to 252. The range for inter is 2 to 253. The range
for type1 is 3 to 254. The range for type2 is 4 to 255.
<no> - This command sets the default route preference value of OSPF in the router.
Default Setting
Intra is 8.
Inter is 10.
Type 1 is 13.
Type 2 is 150.
Command Mode
Router OSPFv3 Config
9.4.2.30 enable (OSPFv3)
This command resets the default administrative mode of OSPF in the router (active).
Syntax
enable
no enable
<no> - This command sets the administrative mode of OSPF in the router to inactive.
Default Setting
Enabled
Command Mode
Router OSPFv3 Config
9.4.2.31 exit-overflow-interval (OSPFv3)
This command configures the exit overflow interval for OSPF. It describes the number of
seconds after entering Overflow state that a router will wait before attempting to leave the
Overflow State. This allows the router to again originate non-default AS-external-LSAs. When
To Next Page
Loading...
Need help?
General
