Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 483/970
Command Mode
Router RIP Config
7.6.2.4 default-information originate
This command is used to set the advertisement of default routes.
Syntax
default-information originate
no default-information originate
no - This command is used to cancel the advertisement of default routes.
Default Setting
Not configured
Command Mode
Router RIP Config
7.6.2.5 default-metric
This command is used to set a default for the metric of distributed routes.
Syntax
default-metric <1-15>
no default-metric
<1 - 15> - a value for default-metric.
no - This command is used to reset the default metric of distributed routes to its default
value.
Default Setting
To Next Page
Loading...
Need help?
General
