QUANTA LB4M - Redistribute; Router-ID

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 467/970
ip ospf mtu-ignore
no ip ospf mtu-ignore
<no> - This command enables the OSPF MTU mismatch detection.
Default Setting
Enabled.
Command Mode
Interface Config
7.3.2.35 router-id
This command sets a 4-digit dotted-decimal number uniquely identifying the router ospf id.
Syntax
router-id <ipaddress>
< ipaddress > - IP Address.
Default Setting
None.
Command Mode
Router OSPF Config
7.3.2.36 redistribute
This command configures OSPF protocol to redistribute routes from the specified source
protocol/routers.