Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 506/970
Default Setting
None
Command Mode
Privileged Exec
User EXEC
Display Message
Group IP This field identifies the multicast Address that is pruned.
Source IP This field displays the IP Address of the source that has pruned.
Source Mask This field displays the network Mask for the prune source. It should be all 1s or
both the prune source and prune mask must match.
Expiry Time (secs) This field indicates the expiry time in seconds. This is the time remaining
for this prune to age out.
8.1.1.6 show ip dvmrp route
This command displays the multicast routing information for DVMRP.
Syntax
show ip dvmrp route
Default Setting
None
Command Mode
Privileged Exec
User EXEC
Display Message
Source Address This field displays the multicast address of the source group.
Source Mask This field displays the IP Mask for the source group.
Upstream Neighbor This field indicates the IP Address of the neighbor which is the source
for the packets for a specified multicast address.
Interface This field displays the interface used to receive the packets sent by the sources.
Metric This field displays the distance in hops to the source subnet. This field has a different
meaning than the Interface Metric field.
Expiry Time(secs) This field indicates the expiry time in seconds. This is the time remaining
for this route to age out.
Up Time(secs) This field indicates the time when a specified route was learnt, in seconds.
8.1.2 Configuration Commands
8.1.2.1 ip dvmrp
To Next Page
Loading...