Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 90/970
port. This is equivalent to registration normal in the IEEE 802.1Q standard.
Tagging: Select the tagging behavior for this port in this VLAN.
Tagged: Specifies to transmit traffic for this VLAN as tagged frames.
Untagged: Specifies to transmit traffic for this VLAN as untagged frames.
6.2.3.3 show vlan association mac
This command displays the VLAN associated with a specific configured MAC address. If no
MAC address is specified, the VLAN associations of all the configured MAC addresses are
displayed.
Syntax
show vlan association mac [<macaddr>]
<macaddr> - enter a MAC Address to display the table entry for the requested MAC
address.
Default Setting
None
Command Mode
Privileged Exec
Display Message
MAC Address: A unicast MAC address for which the switch has forwarding and/or filtering
information. The format is 6 or 8 two-digit hexadecimal numbers that are separated by
colons, for example 01:23:45:67:89:AB. In an IVL system the MAC address will be displayed
as 8 bytes. In an SVL system, the MAC address will be displayed as 6 bytes. Note: This
software version only supports IVL systems.
VLAN ID: There is a VLAN Identifier (VID) associated with each VLAN. The range of the
VLAN ID is 1 to 3965.
6.2.3.4 show vlan association subnet
This command displays the VLAN associated with a specific configured IP-Address and net
mask. If no IP Address and net mask are specified, the VLAN associations of all the
configured IP-subnets are displayed.
Syntax
To Next Page
Loading...
Need help?
General
