Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 132/970
Syntax
show ip igmp snooping querier detail
Default Setting
None
Command Mode
Privileged Exec
User Exec
Display Message
IGMP Snooping Querier Mode: Administrative mode for IGMP Snooping. The default is
disable
Querier Address: Specify the Snooping Querier Address to be used as source address in
periodic IGMP queries. This address is used when no address is configured on the VLAN on
which query is being sent
IGMP Version: Specify the IGMP protocol version used in periodic IGMP queries.
Querier Interval: Specify the time interval in seconds between periodic queries sent by the
snooping querier. The Query Interval must be a value in the range of 1 and 1800. The default
value is 60.
Querier Expiry Interval: Specify the time interval in seconds after which the last querier
information is removed. The Querier Expiry Interval must be a value in the range of 60 and
300. The default value is 60
Last Querier Address: Displays the IP address of the last querier from which a query was
snooped on the VLAN
6.2.7.2 Configuration Commands
6.2.7.2.1. Set IGMP snooping querier admin mode
The user can go to the CLI Global Configuration Mode to set IGMP snooping querier admin
mode, use the ip igmp snooping querier global configuration command. Use the no ip igmp
snooping querier to disable.
Syntax
To Next Page
Loading...
Need help?
General
