QUANTA LB4M - Service Port Commands; Show Serviceport; Show Serviceport Ndp

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 220/970
Command Mode
Interface Configure
6.3.11 Service Port Commands
6.3.11.1 show serviceport
This command displays service port configuration information.
Syntax
show serviceport
Default Setting
None
Command Mode
Privileged Exec
Display Message
IP Address: The IP address of the interface. The factory default value is 0.0.0.0.
Subnet Mask: The IP subnet mask for this interface. The factory default value is 0.0.0.0.
Default Gateway:The default gateway for this IP interface. The factory default value is
0.0.0.0.
ServPort Configured Protocol Current: Indicates what network protocol was used on
thelast, or current power-up cycle, if any.
Burned In MAC Address: The burned in MAC address used for in-band connectivity.
6.3.11.2 show serviceport ndp
This command displays IPv6 Neighbor entries.