Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 531/970
This command displays the system-wide information for PIM-DM.
Syntax
show ip pimdm
Default Setting
None
Command Mode
Privileged Exec
Display Message
Admin Mode: This field indicates whether PIM-DM is enabled or disabled. This is a
configured value.
Interface: Valid slot and port number separated by forward slashes.
Interface Mode: This field indicates whether PIM-DM is enabled or disabled on this interface.
This is a configured value.
Protocol State: This field indicates the current state of PIM-DM on this interface. Possible
values are Operational or Non-Operational.
8.4.1.2 show ip pimdm interface
This command displays the interface information for PIM-DM on the specified interface.
Syntax
show ip pimdm interface <slot/port>
<slot/port > - Interface number.
Default Setting
None
Command Mode
Privileged Exec
Display Message
Interface Mode: This field indicates whether PIM-DM is enabled or disabled on the specified
interface. This is a configured value.
Hello Interval (secs): This field indicates the frequency at which PIM hello messages are
To Next Page
Loading...
Need help?
General
