Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 530/970
the last hop router.
Default Setting
None
Command Mode
Privileged Exec
8.3.2.9 disable ip multicast mdebug mtrace
This command is used to disable the processing capability of mtrace query on this router. If the
mode is enabled, the mtrace queries received by the router are processed and forwarded
appropriately by the router. If the mode is disabled, this router does not respond to the mtrace
queries it receives from other router devices.
Syntax
disable ip multicast mdebug mtrace
no disable ip multicast mdebug mtrace
no - This command is used to enable the processing capability of mtrace query on this
router. If the mode is enabled, the mtrace queries received by the router are processed
and forwarded appropriately by the router. If the mode is disabled, this router does not
respond to the mtrace queries it receives from other router devices.
Default Setting
None
Command Mode
Global Config
8.4 Protocol Independent Multicast – Dense Mode (PIM-DM) Commands
8.4.1 Show Commands
8.4.1.1 show ip pimdm
To Next Page
Loading...