Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 459/970
Syntax
default-metric <1-16777215>
no default-metric
<1-16777215> - The range of default metric is 1 to 16777215.
<no> - This command configures the default advertisement of default routes.
Default Setting
None
Command Mode
Router OSPF Config
7.3.2.22 distance ospf
This command sets the route preference value of OSPF in the router. Lower route preference
values are preferred when determining the best route. The type of OSPF can be intra, inter,
type-1, or type-2. The OSPF specification (RFC 2328) requires that preferences must be given
to the routes learned via OSPF in the following order: intra < inter < type-1 < type-2.
Syntax
dist
ance osp
f {intra
| inter | ty
pe1 | type2} [<preference>]
no distance ospf {intra | inter | type1 | type2}
<preference> -
The range for intra is 1 to 252. The range for inter is 2 to 253. The range for type1 is 3 to 254. The range for type2 is 4 to 255.
<no> - This command sets the default route preference value of OSPF in the router.
Default Setting
The default preference value for intra is 8. The default preference value for inter is 10. The
default preference value for type 1 is 13. The default preference value for type 2 is 150.
Command Mode
To Next Page
Loading...
Need help?
General
