Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 492/970
< 3-maxadvertinterval> - The range is 3 to maxadvertinterval seconds.
no - This command sets the minimum time to 450.
Default Setting
The default value is 450.
Command Mode
Global Config
7.7.7 ip irdp preference
This command configures the preferability of the address as a default router address, relative
to other router addresses on the same subnet.
Syntax
ip irdp preference < -2147483648-2147483647>
no ip irdp preference
< -2147483648-2147483647> - The range is -2147483648 to 2147483647.
no - This command sets the preference to 0.
Default Setting
The default value is 0.
Command Mode
Global Config
7.8 VLAN Routing Commands
7.8.1 show ip vlan
This command displays the VLAN routing information for all VLANs with routing enabled in the
system.
Syntax
To Next Page
Loading...
Need help?
General
