QUANTA LB4M - Show Eventlog

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 59/970
Default Setting
None
Command Mode
Privileged Exec
Display Message
Current Time displays system time
6.1.3 show eventlog
This command displays the event log, which contains error messages from the system, in the
Primary Management System or in the specified unit. The event log is not cleared on a system
reset.
Syntax
show eventlog [unit]
unit - The unit number of the remote system. The range is 1 to 8.
Default Setting
None
Command Mode
Privileged Exec
Display Message
File: The file in which the event originated.
Line: The line number of the event.
Task Id: The task ID of the event.
Code: The event code.
Time: The time this event occurred.
Note: Event log information is retained across a switch reset.