Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 434/970
Syntax
ip mtu <68-1500>
no ip mtu <68-1500>
<68-1500> - The IP MTU on a routing interface. The range is 68 to 1500.
no - Reset the ip mtu to the default value.
Default Setting
The default value is 1500.
Command Mode
Interface Config
7.2.2.10 encapsulation
This command configures the link layer encapsulation type for the packet.
Syntax
encapsulation {ethernet | snap}
ethernet - The link layer encapsulation type is ethernet.
snap - The link layer encapsulation type is SNAP.
Default Setting
The default value is ethernet.
Command Mode
Interface Config
Restrictions
Routed frames are always Ethernet encapsulated when a frame is routed to a VLAN.
7.3 Open Shortest Path First (OSPF) Commands
7.3.1 Show Commands
To Next Page
Loading...
Need help?
General
