Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 495/970
7.9.1.3 show ip vrrp interface
This command displays all configuration information of a virtual router configured on a specific
interface. Note that the information will be displayed only when the IP address of the specific
interface is configured.
Syntax
show ip vrrp interface <slot/port> [ <vrid>]
<slot/port> - Valid slot and port number separated by forward slashes.
<vrid> - Virtual router ID.
Default Setting
None
Command Mode
Privileged Exec, User Exec
Display Message
VRID Represents the router ID of the virtual router.
Primary IP Address This field represents the configured IP Address for the Virtual router.
VMAC address Represents the VMAC address of the specified router.
Authentication type Represents the authentication type for the specific virtual router.
Priority Represents the priority value for the specific virtual router.
Advertisement interval Represents the advertisement interval for the specific virtual router.
Pre-Empt Mode Is the preemption mode configured on the specified virtual router.
Administrative Mode Represents the status (Enable or Disable) of the specific router.
State Represents the state (Master/backup) of the specific virtual router
7.9.1.4 show ip vrrp interface stats
This command displays the statistical information about each virtual router configured on the
switch.
Syntax
show ip vrrp interface stats <slot/port> [ <vrid>]
<slot/port> - Valid slot and port number separated by forward slashes.
<vrid> - Virtual router ID.
Default Setting
None
Command Mode
To Next Page
Loading...
Need help?
General
