Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 578/970
Display Messages
IP Address Shows the IPv6 address of the interface.
ifIndex Shows the interface index number associated with the interface.
OSPF Admin Mode Shows whether the admin mode is enabled or disabled.
OSPF Area ID Shows the area ID associated with this interface.
Router Priority Shows the router priority. The router priority determines which router is the
designated router.
Retransmit Interval Shows the frequency, in seconds, at which the interface sends LSA.
Hello Interval Shows the frequency, in seconds, at which the interface sends Hello packets.
Dead Interval Shows the amount of time, in seconds, the interface waits before assuming a
neighbor is down.
LSA Ack Interval Shows the amount of time, in seconds, the interface waits before sending
an LSA acknowledgement after receiving an LSA.
Iftransit Delay Interval Shows the number of seconds the interface adds to the age of LSA
packets before transmission.
Authentication Type Shows the type of authentication the interface performs on LSAs it
receives.
Metric Cost Shows the priority of the path. Low costs have a higher priority than high
costs.
OSPF MTU-ignore Shows whether to ignore MTU mismatches in database descriptor
packets sent from neighboring routers.
The following information only displays if OSPF is initialized on the interface:
OSPF Interface Type Broadcast LANs, such as Ethernet and IEEE 802.5, take the value
broadcast. The OSPF Interface Type will be 'broadcast'.
State The OSPF Interface States are: down, loopback, waiting, point-to-point, designated
router, and backup designated router.
Designated Router The router ID representing the designated router.
Backup Designated Router The router ID representing the backup designated router.
Number of Link Events The number of link events.
Metric Cost The cost of the OSPF interface.
9.4.1.8 show ipv6 ospf interface brief
This command displays brief information for the IFO object or virtual interface tables.
Syntax
To Next Page
Loading...