QUANTA LB4M - Area Virtual-Link Transmit-Delay (Ospfv3); Default-Information Originate (Ospfv3)

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 597/970
interface on the interface identified by <areaid> and <neighborid>.
Default Setting
5 seconds.
Command Mode
Router OSPFv3 Config
9.4.2.26 area virtual-link transmit-delay (OSPFv3)
This command configures the transmit delay for the OSPF virtual interface on the virtual
interface identified by <areaid> and <neighborid>.
Syntax
area <areaid> virtual-link <neighborid> transmit-delay <0-3600>
no area <areaid> virtual-link <neighborid> transmit-delay
<areaid> - Area ID.
<neighborid> - Router ID of the neighbor.
<0-3600> - The range of the transmit delay is 0 to 3600.
<no> - This command configures the default transmit delay for the OSPF virtual interface
on the virtual interface identified by <areaid> and <neighborid>.
Default Setting
1 second.
Command Mode
Router OSPFv3 Config
9.4.2.27 default-information originate (OSPFv3)
This command is used to control the advertisement of default routes.
Syntax
default-information originate [always] [metric <1-16777215>] [metric-type {1 | 2}]
no default-information originate [metric] [metric-type]
[always] - Sets the router advertise 0.0.0.0/0.0.0.0.