Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 499/970
Default Setting
no authentication
Command Mode
Interface Config
7.9.2.5 ip vrrp preempt
This command sets the preemption mode value for the virtual router configured on a specified
interface.
Syntax
ip vrrp <1-255> preempt
no ip vrrp <1-255> preempt
<1-255> - The range of virtual router ID is 1 to 255.
<no> - This command sets the default preemption mode value for the virtual router
configured on a specified interface.
Default Setting
Enabled
Command Mode
Interface Config
7.9.2.6 ip vrrp priority
This command sets the priority value for the virtual router configured on a specified interface.
Syntax
ip vrrp <1-255> priority <1-255>
no ip vrrp <1-255> priority
<1-255> - The range of virtual router ID is 1 to 255.
<1-254> - The range of priority is 1 to 255.
<no> - This command sets the default priority value for the virtual router configured on a
To Next Page
Loading...
Need help?
General
