QUANTA LB4M User Manual

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 437/970
Privileged Exec, User Exec
Display Messages
Type: The type of the route to the destination. It can be either:
intra — Intra-area route
inter — Inter-area route
Router ID: Router ID of the destination
Cost: Cost of using this route
Area ID: The area ID of the area from which this route is learned.
Next Hop: Next hop toward the destination
Next Hop Intf: The outgoing router interface to use when forwarding traffic to the next hop.
7.3.1.4 show ip ospf asbr
This command displays the internal OSPF routing table entries to Autonomous System
Boundary Routers (ASBR). This command takes no options.
Syntax
show ip ospf asbr
Default Setting
None
Command Mode
Privileged Exec, User Exec
Display Messages
Type: The type of the route to the destination. It can be either:
intra — Intra-area route
inter — Inter-area route
Router ID: Router ID of the destination
Cost: Cost of using this route
Area ID: The area ID of the area from which this route is learned.
Next Hop: Next hop toward the destination
Next Hop Intf: The outgoing router interface to use when forwarding traffic to the next hop.
7.3.1.5 show ip ospf database
This command displays information about the link state database when OSPF is enabled. If
you do not enter any parameters, the command displays the LSA headers for all areas. Use
the optional <areaid> parameter to display database information about a specific area. Use the
optional parameters to specify the type of link state advertisements to display. Use
asbrsummary to show the autonomous system boundary router (ASBR) summary LSAs. Use
external to display the external LSAs. Use network to display the network LSAs. Use
nssaexternal to display NSSA external LSAs. Use router to display router LSAs. Use summary
to show the LSA database summary information. Use <lsid> to specify the link state ID (LSID).
The value of <lsid> can be an IP address or an integer in the range of 0-4294967295. Use

QUANTA LB4M Specifications

General

Brand	QUANTA
Model	LB4M
Category	Switch
Language	English