Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 205/970
<1-65535> - HTTP Port value.
no - This command is used to reset the http port to the default value.
Default Setting
80
Command Mode
Global Config
6.3.6.4 ip http server
This command enables access to the switch through the Web interface. When access is
enabled, the user can login to the switch from the Web interface. When access is disabled, the
user cannot login to the switch's Web server.
Disabling the Web interface takes effect immediately. All interfaces are affected.
Syntax
ip http server
no ip http server
no - This command disables access to the switch through the Web interface. When
access is disabled, the user cannot login to the switch's Web server.
Default Setting
Enabled
Command Mode
Global Config
6.3.6.5 ip http secure-port
This command is used to set the SSLT port where port can be 1-65535 and the default is port
443.
To Next Page
Loading...
Need help?
General
