Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 303/970
<name> - Name of the time zone, usually an acronym. (Range: 1-15 characters)
<0-12> - Number of hours before/after UTC. (Range: 0-12 hours)
<0-59> - Number of minutes before/after UTC. (Range: 0-59 minutes)
before-utc - Sets the local time zone before (east) of UTC.
after-utc - Sets the local time zone after (west) of UTC.
Default Setting
Taipei 08:00 After UTC
Command Mode
Global Config
6.11 MAC-Based Voice VLAN Commands
6.11.1 Show Commands
6.11.1.1 show voice-vlan
This command uses to display the configuration status of the Voice VLAN on the switch.
Syntax
show voice-vlan
Default Setting
None
Command Mode
Privileged Exec
Display Message
Vlan Voice-Vlan status: The voice-vlan status (Enable/Disable).
Voice-Vlan ID: The specified VLAN to vloce vlan.
Voice Name: The voice-name is the name of the voice device, which is to help the device
management.
To Next Page
Loading...
Need help?
General
