Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 405/970
no ipv6 traffic-filter <name> [vlan <vlan-id>] in [<1-4294967295>]
no - This command removes an IPv6 ACL identified by <name> from the interface(s) in a
given direction
Default Setting
None
Command Mode
Global Config
Interface Config
6.20.2.5 ipv6 traffic-filter
This command either
attaches a
specific IP
ACL
identi
fied by <accesslistnumber
> to an
interface or associates with a VLAN ID in a given direction.
An optional sequence number may be specified to indicate the order of this IP access list
relative to other IP access lists already assigned to this interface and direction. A lower number
indicates higher precedence order. If a sequence number is already in use for this interface and
direction, the specified access list replaces the currently attached IP access list using that
sequence number. If the sequence number is not specified for this command, a sequence
number that is one greater than the highest sequence number currently in use for this interface
and direction is used.
Syntax
ip access-group <accesslistnumber> [vlan <vlan-id>] in [<1-4294967295>]
no ip access-group <accesslistnumber> [vlan <vlan-id>] in
no - This command removes a specified IP ACL from an interface.
Default Setting
None
Command Mode
Global Config
6.20.2.6 mac access-group
This command either attaches a specific MAC Access Control List (ACL) identified by <name>
to an interface, or associates it with a VLAN ID, in a given direction. The <name> parameter
To Next Page
Loading...
Need help?
General
