Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 574/970
show ipv6 ospf abr
Default Setting
None
Command Mode
Privileged Exec, User Exec
Display Messages
Type: The type of the route to the destination. It can be either:
intra — Intra-area route
inter — Inter-area route
Router ID: Router ID of the destination
Cost: Cost of using this route
Area ID: The area ID of the area from which this route is learned.
Next Hop: Next hop toward the destination
Next Hop Intf: The outgoing router interface to use when forwarding traffic to the next hop.
9.4.1.3 show ipv6 ospf area
This
command
display
s i
nformation
about
the
area.
The
<areaid>
id
entifies
the
OSPF
area
t
hat
is being displayed.
Syntax
show ipv6 osp
f
area <areaid>
Default Setting
None
Command Mode
Privileged Exec, User Exec
Display Messages
AreaID Is the area id of the requested OSPF area.
External Routing Is a number representing the external routing capabilities for this area.
Spf Runs Is the number of times that the intra-area route table has been calculated using
this area's link-state database.
Area Border Router Count The total number of area border routers reachable within this
area.
Area LSA Count Total number of link-state advertisements in this area's link-state database,
excluding AS External LSAs.
Area LSA Checksum A number representing the Area LSA Checksum for the specified
AreaID excluding the external (LS type 5) link-state advertisements.
Stub Mode Represents whether the specified Area is a stub area or not. The possible values
To Next Page
Loading...
Need help?
General
