Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 106/970
Default Setting
None
Command Mode
Interface Config
6.2.4 Double VLAN commands
6.2.4.1 show dvlan-tunnel/ dot1q-tunnel
This command is used without the optional parameters to display all interfaces enabled for
Double VLAN Tunneling. Use the optional parameters to display detailed information about
Double VLAN Tunneling for the specified interface or all interfaces.
Syntax
show {dot1q-tunnel|dvlan-tunnel} [interface {<slot/port>|all}]
Default Setting
None
Command Mode
Privileged Exec
Display Message
Interfaces Enabled for DVLAN Tunneling: Valid interface(s) support(s) DVLAN Tunneling.
When using ‘show {dot1q-tunnel|dvlan-tunnel} interface’:
Interface: Valid slot and port number separated by forward slashes.
Mode: This field specifies the administrative mode through which Double VLAN Tunneling
can be enabled or disabled. The default value for this field is disabled.
EtherType This field represents a 2-byte hex EtherType to be used as the first 16 bits of the
DVLAN tunnel. There are three different EtherType tags. The first is 802.1Q, which
represents the commonly used value of 0x8100. The second is vMAN, which represents the
commonly used value of 0x88A8. If EtherType is not one of these two values, then it is a
custom tunnel value, representingany value in the range of 0 to 65535.
6.2.4.2 switchport dvlan-tunnel/ dot1q-tunnel ethertype
This command configures the ether-type for all interfaces. The ether-type may have the values
of 802.1Q, vMAN, or custom. If the ether-type has a value of custom, the optional value of the
custom ether type must be set to a value from 0 to 65535.
To Next Page
Loading...
Need help?
General
