QUANTA LB4M - Configuration Commands; Mac Access-List Extended; Mac Access-List Extended Rename

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 397/970
this interface and direction is used. Valid range is (1 to 4294967295).
6.19.2 Configuration Commands
6.19.2.1 mac access-list extended
This command creates a MAC Access Control List (ACL) identified by <name>, consisting of
classification fields defined for the Layer 2 header of an Ethernet frame. The <name>
parameter is a case-sensitive alphanumeric string from 1 to 31 characters uniquely identifying
the MAC access list. If a MAC ACL by this name already exists, this command enters
Mac-Access-List config mode to allow updating the existing ACL.
Syntax
mac access-list extended <name>
no mac access-list extended <name>
<name> - It uniquely identifies the MAC access list.
Default Setting
None
Command Mode
Global Config
6.19.2.2 mac access-list extended rename
This command changes the name of a MAC Access Control List (ACL). The <name>
parameter is the name of an existing MAC ACL. The <newname> parameter is a
case-sensitive alphanumeric string from 1 to 31 characters uniquely identifying the MAC
access list. This command fails if a MAC ACL by the name <newname> already exists.
Syntax
mac access-list extended rename <oldname> <newname>