Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 403/970
this command.
Default Setting
None
Command Mode
Global Config
6.20.2.2 ipv6 access-list rename
This command changes the name of an IPv6 ACL. The <name> parameter is the name of an
existing IPv6 ACL. The <newname> parameter is a case-sensitive alphanumeric string from 1
to 31 characters uniquely identifying the IPv6 access list.
This command fails is an IPv6 ACL by the name <newname> already exists.
Syntax
ipv6 access-list rename <name> <newname>
Default Setting
None
Command Mode
Global Config
6.20.2.3 {deny | permit} (IPv6)
This command creates a new rule for the current IPv6 access list. Each rule is appended to the
list of configured rules for the list.
Note: The ‘no’ form of this command is not supported, since the rules within an IPv6 ACL
cannot be deleted individually. Rather, the entire IPv6 ACL must be deleted and respecified.
Note: An implicit ‘deny all’ IPv6 rule always terminates the access list.
A rule may either deny or permit traffic according to the specified classification fields. At a
minimum, either the ‘every’ keyword or the protocol, source address, and destination address
values must be specified. The source and destination IPv6 address fields may be specified
using the keyword ‘any’ to indicate a match on any value in that field. The remaining command
parameters are all optional, but the most frequently used parameters appear in the same
relative order as shown in the command format.
To Next Page
Loading...
Need help?
General
