QUANTA LB4M - Ip Ssh; Ip Ssh Protocol

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 208/970
SSH Timeout: This field is the inactive timeout value for incoming SSH sessions to the
switch.
6.3.7.2 ip ssh
This command is used to enable SSH.
Syntax
ip ssh
no ip ssh
no - This command is used to disable SSH.
Default Setting
Disabled
Command Mode
Global Config
6.3.7.3 ip ssh protocol
This command is used to set or remove protocol levels (or versions) for SSH. Either SSH1 (1),
SSH2 (2), or both SSH 1 and SSH 2 (1 and 2) can be set.
Syntax
ip ssh protocol <protocollevel1> [protocollevel2]
<protocollevel1 - 2> - The protocol level can be set to SSH1, SSH2 or to both SSH 1 and
SSH 2.
Default Setting
SSH1 and SSH2
Command Mode