QUANTA LB4M - Configuration Commands; Ip Pimsm; Ip Pimsm Message-Interval

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 540/970
Default Setting
None
Command Mode
Privileged Exec
Display Message
Address: This field displays the IP address of the RP.
Group Address: This field displays the group address supported by the RP.
Group Mask: This field displays the group mask for the group address.
8.5.2 Configuration Commands
8.5.2.1 ip pimsm
This command sets administrative mode of PIM-SM multicast routing across the router to
enabled. IGMP must be enabled before PIM-SM can be enabled.
Syntax
ip pimsm
no ip pimsm
no - This command sets administrative mode of PIM-SM multicast routing across the
router to disabled. IGMP must be enabled before PIM-SM can be enabled.
Default Setting
Disbaled
Command Mode
Global Config
8.5.2.2 ip pimsm message-interval
This command is used to configure the global join/prune interval for PIM-SM router. The
join/prune interval is specified in seconds. This parameter can be configured to a value from 10
to 3600.