Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 508/970
Syntax
ip dvmrp metric <value>
no ip dvmrp metric <value>
<value> - This field has a range of 1 to 63.
no - This command resets the metric for an interface to the default value. This value is
used in the DVMRP messages as the cost to reach this network.
Default Setting
1
Command Mode
Interface Config
8.2
Internet Group Management Protocol (IGMP) Commands
This section provides a detailed explanation of the IGMP commands. The commands are
divided into the following different groups:
Show commands are used to display device settings, statistics and other information.
Configuration commands are used to configure features and options of the switch. For every
configuration command there is a show command that will display the configuration setting.
8.2.1 Show Commands
8.2.1.1 show ip igmp
This command displays the system-wide IGMP information.
Syntax
To Next Page
Loading...
Need help?
General
