QUANTA LB4M - Cluster Rcommand Commander; Cluster Reset Member

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 623/970
Syntax
cluster rcommand member <mem-id>
<mem-id> - The cluster member id.
Default Setting
None
Command Mode
Global Config
10.1.2.10 cluster rcommand commander
This command is used to configure the commander switch.
.
Syntax
cluster rcommand commander
Default Setting
None
Command Mode
Global Config
10.1.2.11 cluster reset member
This command can be used to reset the member switch(s)
.
Syntax
cluster reset member <mem-id>
<mem-id> - The cluster member id.
Default Setting
None
Command Mode