EasyManuals Logo

QUANTA LB4M User Manual

QUANTA LB4M
970 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #400 background imageLoading...
Page #400 background image
UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 400/970
This command creates an Access Control List (ACL) that is identified by the parameter.
Syntax
access-list {(<1-99> {deny | permit} {every | <srcip> <srcm ask>}) | ( {<100-
199> {deny |
permit} {every | {{icmp | igmp | ip | tcp | udp |
<number>} any | <srcip> <srcmask> [{eq
{<0-65535> | <portkey>}]( any | <dstip> <dstmask>) [{eq {<0-
65535> | <portkey>}]
{[precedence <precedence>] | [tos <tos> <tosmask>] | [dsc
p <dscp>] [log]
[assign-queue <queue-id>] [{mirror | redirect} <slot/port>] [<rule-id>]}}}})}
<accesslistnumber>. The ACL number is an integer from 1 to 199. The range 1 to 99 is for
the normal ACL List and 100 to 199 is for the extended ACL List.
permit or deny. The ACL rule is created with two options. The protocol to filter for an ACL rule
is specified by giving the protocol to be used like icmp ,igmp ,ip ,tcp, udp. The command
specifies a source ip address and source mask for match condition of the ACL rule specified by
the srcip and srcmask parameters. The source layer 4 port match condition for the ACL rule
is specified by the port value parameter.
<portvalue> uses a single keyword notation and currently has the values of domain, echo,
ftp, ftpdata, http, smtp, snmp, telnet, tftp, and www. Each of these values translates into its
equivalent port number, which is used as both the start and end of a port range. The command
specifies a destination ip address and destination mask for match condition of the ACL rule
specified by the dstip and dstmask parameters. The command specifies the TOS for an ACL
rule depending on a match of precedence or DSCP values using the parameters tos, tosmask,
dscp.
Default Setting
None
Command Mode
Global Config
6.19.2.6 no access-list
This command deletes an ACL that is identified by the parameter <accesslistnumber> from the
system.
Syntax
no access-list {<1-99> | <100-199>}
Note: The ACL number is an integer from 1 to 199. The range 1 to 99 is for the normal ACL List
and 100 to 199 is for the extended ACL List.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the QUANTA LB4M and is the answer not in the manual?

QUANTA LB4M Specifications

General IconGeneral
BrandQUANTA
ModelLB4M
CategorySwitch
LanguageEnglish

Related product manuals