Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 466/970
The default retransmit interval is 5 seconds.
Command Mode
Interface Config
7.3.2.33 ip ospf transmit-delay
This command sets the OSPF Transmit Delay for the specified interface. The transmit delay is
specified in seconds. In addition, it sets the estimated number of seconds it takes to transmit a
link state update packet over this interface.
Syntax
ip ospf transmit-delay <1-3600>
no ip ospf transmit-delay
< 1-3600 > - The range of transmit delay is 1 to 3600.
<no> - This command sets the default OSPF Transit Delay for the specified interface.
Default Setting
The default transmit delay is 1 second.
Command Mode
Interface Config
7.3.2.34 ip ospf mtu-ignore
This command disables OSPF maximum transmission unit (MTU) mismatch detection. OSPF
Database Description packets specify the size of the largest IP packet that can be sent without
fragmentation on the interface. When a router receives a Database Description packet, it
examines the MTU advertised by the neighbor. By default, if the MTU is larger than the router
can accept, the Database Description packet is rejected and the OSPF adjacency is not
established.
Syntax
To Next Page
Loading...
Need help?
General
