QUANTA LB4M - Area Nssa (Osfpv3); Area Nssa Default-Info-Originate (Ospfv3)

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 590/970
Default Setting
None
Command Mode
Router OSPFv3 Config
9.4.2.13 area nssa (OSFPv3)
This command configures the specified areaid to function as an NSSA.
Syntax
area <areaid> nssa
no area <areaid> nssa
<areaid> - Area ID.
no - This command disables nssa from the specified area id.
Default Setting
None
Command Mode
Router OSPFv3 Config
9.4.2.14 area nssa default-info-originate (OSPFv3)
This command configures the metric value and type for the default route advertised into the
NSSA. The optional metric parameter specifies the metric of the default route and is to be in a
range of 1-16777214. If no metric is specified, the default value is 10. The metric type can be
comparable (nssa-external 1) or non-comparable (nssa-external 2).
Syntax
area <areaid> nssa default-info-originate [<1-16777215>] [{comparable
|
non-comparable}]
no area <areaid> nssa default-info-originate [<1-16777215>] [{comparable
|
non-comparable}]
<areaid> - Area ID.