Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 588/970
become the designated router on this network.
Syntax
ipv6 ospf priority <0-255>
no ipv6 ospf priority
<no> - This command sets the default OSPF priority for the specified router interface.
Default Setting
1, which is the highest router priority
Command Mode
Interface Config
9.4.2.9 ipv6 ospf retransmit-interval
This command sets the OSPF retransmit Interval for the specified interface. The retransmit
interval is specified in seconds. The value for <seconds> is the number of seconds between
link-state advertisement retransmissions for adjacencies belonging to this router interface. This
value is also used when retransmitting database description and link-state request packets.
Valid values range from 0 to 3600 (1 hour).
Syntax
ipv6 ospf retransmit-interval <seconds>
no ipv6 ospf retransmit-interval
<no> - This command sets the default OSPF retransmit Interval for the specified interface.
Default Setting
5
Command Mode
Interface Config
9.4.2.10 ipv6 ospf transmit-delay
This command sets the OSPF Transit Delay for the specified interface. The transmit delay is
specified in seconds. In addition, it sets the estimated number of seconds it takes to transmit a
link state update packet over this interface. Valid values for <seconds> range from 1 to 3600 (1
To Next Page
Loading...
Need help?
General
