Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 620/970
The default value is 60 (seconds)
Command Mode
Global Config
10.1.2.3 cluster commander
This command will create a commander switch of the switch cluster network management.
Syntax
cluster commander <cluster-name>
no cluster commander
<cluster-name> - The name of the switch cluster.
no - This command will remove a commander switch from the switch cluster network
management.
Default Setting
none
Command Mode
Global Config
10.1.2.4 cluster member
This command will add a candidate switch to the switch cluster network management in the
commander switch.
Syntax
cluster member {candidate-sn <cand-sn> | mac-address <mac-add> [<mem-id>]}
no cluster member <mem-id >
<cand-sn> - The candidate serial number.
<mac-add> - the switch mac address.
<mem-id> - specify the member id of the switch cluster network management.
no - This command will remove a commander switch from the switch cluster network
management.
Default Setting
none
To Next Page
Loading...
Need help?
General
