Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 498/970
None
Command Mode
Interface Config
7.9.2.3 ip vrrp mode
This command enables the virtual router configured on the specified interface. Enabling the
status field starts a virtual router.
Syntax
ip vrrp <1-255> mode
no ip vrrp <1-255> mode
<1-255> - The range of virtual router ID is 1 to 255.
<no> - Disable the virtual router configured on the specified interface. Disabling the
status field stops a virtual router.
Default Setting
Disabled
Command Mode
Interface Config
7.9.2.4 ip vrrp authentication
This command sets the authorization details value for the virtual router configured on a
specified interface.
Syntax
ip vrrp <1-255> authentication <key>
no ip vrrp <1-255> authentication
<1-255> - The range of virtual router ID is 1 to 255.
<key> - A text password used for authentication.
<no> - This command sets the default authorization details value for the virtual router
configured on a specified interface.
To Next Page
Loading...
Need help?
General
