Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 174/970
Command Mode
Global Config
6.3.1.5 ip address
This command sets the IP Address, and subnet mask. The IP Address and the gateway must
be on the same subnet.
Syntax
ip address <ipaddr> <netmask>
no ip address
<ipaddr> - IP address
<netmask> - Subnet Mask
no - Restore the default IP address and Subnet Mask
Default Setting
IP address: 0.0.0.0
Subnet Mask: 0.0.0.0
Command Mode
Interface-Vlan Config
Command Usage
Once the IP address is set, the VLAN ID’s value will be assigned to management VLAN.
6.3.1.6 ip default-gateway
This command sets the IP Address of the default gateway.
Syntax
ip default-gateway <gateway>
no ip default-gateway
To Next Page
Loading...
Need help?
General
