Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 299/970
no - This command will reset the poll interval for SNTP broadcast client back to its default
value.
Default Setting
6
Command Mode
Global Config
6.10.2.2 sntp client mode
This command will enable Simple Network Time Protocol (SNTP) client mode and optionally
setting the mode to either broadcast, multicast, or unicast.
Syntax
sntp client mode [broadcast | unicast]
no sntp client mode
no - This command will disable Simple Network Time Protocol (SNTP) client mode.
Default Setting
None
Command Mode
Global Config
6.10.2.3 sntp client port
This command will set the SNTP client port id and polling interval in seconds.
To Next Page
Loading...
Need help?
General
