QUANTA LB4M - Ipv6 Routing Commands; Show Commands; Show Ipv6 Brief

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 555/970
Syntax
interface loopback <0-7>
no interface loopback <0-7>
no - This command removes the loopback interface and associated configuration
parameters for the specified loopback interface.
Default Setting
Disabled
Command Mode
Global Config
9.3 IPv6 Routing Commands
This section describes the IPv6 commands you use to configure IPv6 on the system and on the
interfaces. This section also describes IPv6 management commands and show commands.
9.3.1 Show Commands
9.3.1.1 show ipv6 brief
This command displays the IPv6 status of forwarding mode and IPv6 unicast routing mode.
Syntax
show ipv6 brief
Default Setting
None
Command Mode
Privileged Exec
Display Message
IPv6 Forwarding Mode: Shows whether the IPv6 forwarding mode is enabled.
IPv6 Unicast Routing Mode: Shows whether the IPv6 unicast routing mode is enabled.