QUANTA LB4M - Dot1 X Host-Mode

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 274/970
auto
Command Mode
Global Config
This command sets the authentication mode to be used on the specified port. The control
mode may be one of the following.
force-unauthorized: The authenticator PAE unconditionally sets the controlled port to
unauthorized.
force-authorized: The authenticator PAE unconditionally sets the controlled port to
authorized.
auto: The authenticator PAE sets the controlled port mode to reflect the outcome of the
authentication exchanges between the supplicant, authenticator, and the authentication server.
Syntax
dot1x port-control {auto | force-authorized | force-unauthorized}
no dot1x port-control
no - This command sets the authentication mode to be used on the specified port to 'auto'.
Default Setting
auto
Command Mode
Interface Config
6.8.3.7 dot1x host-mode
The command will configure the host mode to a specified port, use the dot1x host-mode
{single-host | multi-host} interface configuration command. Use the no dot1x host-mode to
return authentication mode to default value.
Syntax
dot1x host-mode {single-host | multi-host}
no dot1x host-mode