EasyManuals Logo

QUANTA LB4M User Manual

QUANTA LB4M
970 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #222 background imageLoading...
Page #222 background image
UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 222/970
Syntax
serviceport ip <ipaddr> <netmask> [gateway]
<ipaddr> - The user manually configures IP address for this switch.
<netmask> - The user manually configures Subnet Mask for this switch.
gateway - The user manually configures gateway server for this switch.
Default Setting
None
Command Mode
Privileged Exec
6.3.11.4 serviceport protocol
This command specifies the network management port configuration protocol. If you modify
this value, the change is effective immediately. If you use the bootp parameter, the switch
periodically sends requests to a BootP server until a response is received. If you use the dhcp
parameter, the switch periodically sends requests to a DHCP server until a response is
received. If you use the none parameter, you must configure the network information for the
switch manually.
Syntax
serviceport protocol {none | bootp | dhcp}
none - Configure the network information for the switch manually.
bootp - Periodically sends requests to a BootP server until a response is received.
dhcp - Periodically sends requests to a DHCP server until a response is received.
Default Setting
None
Command Mode
Privileged Exec

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the QUANTA LB4M and is the answer not in the manual?

QUANTA LB4M Specifications

General IconGeneral
BrandQUANTA
ModelLB4M
CategorySwitch
LanguageEnglish

Related product manuals