Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 311/970
Syntax
show lldp remote-device detail <slot/port>
<slot/port> - Displays a specific interface.
Default Setting
None
Command Mode
Privileged Exec
Display Message
Local Interface: Identifies the interface that received the LLDPDU from the remote device.
Chassis ID Subtype: Shows the type of identification used in the Chassis ID field.
Chassis ID: Identifies the chassis of the remote device.
Port ID Subtype: Identifies the type of port on the remote device.
Port ID: Shows the port number that transmitted the LLDPDU.
System Name: Shows the system name of the remote device.
System Description: Describes the remote system by identifying the system name and
versions of hardware, operating system, and networking software supported in the device.
Port Description: Describes the port in an alpha-numeric format. The port description is
configurable.
System Capabilities Supported: Indicates the primary function(s) of the device.
System Capabilities Enabled: Shows which of the supported system capabilities are
enabled.
Management Address: For each interface on the remote device with an LLDP agent, lists
the type of address the remote LLDP agent uses and specifies the address used to obtain
information related to the device.
Time To Live: Shows the amount of time (in seconds) the remote device's information
received in the LLDPDU should be treated as valid information.
6.12.1.6 show lldp local-device
This command uses to display summary information about the advertised LLDP local data.
This command can display summary information or detail for each interface.
Syntax
To Next Page
Loading...
Need help?
General
