Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 268/970
locked port.
Syntax
show port-security violation <slot/port>
Default Setting
None
Command Mode
Privileged Exec
Display Message
MAC address MAC address of discarded packet on locked ports.
6.8.2 Configuration Commands
6.8.2.1 authentication login
This command creates an authentication login list. The <listname> is up to 15 alphanumeric
characters and is not case sensitive. Up to 10 authentication login lists can be configured on
the switch. When a list is created, the authentication method “local” is set as the first method.
When the optional parameters “method1”, “method 2”, and/or “method 3” are used, an ordered
list of methods are set in the authentication login list. If the authentication login list does not
exist, a new authentication login list is first created and then the authentication methods are set
in the authentication login list. The maximum number of authentication login methods is three.
The possible method values are local, radius, reject, and tacacs.
The value of local indicates that the user’s locally stored ID and password are used for
authentication. The value of radius indicates that the user’s ID and password will be
authenticated using the RADIUS server. The value of reject indicates that the user is never
authenticated. The value of tacacs indicates that the user’s ID and password will be
authenticated using the TACACS.
To authenticate a user, the authentication methods in the user’s login will be attempted in order
until an authentication attempt succeeds or fails.
Note that the default login list included with the default configuration cannot be changed.
To Next Page
Loading...
Need help?
General
